Programming guide

  • Configuration Menu:

    Mode 1 - Group Selection
    ├─ Group 1: (Moonlight) → 2% → 20% → 100%
    ├─ Group 2: (Moonlight) → 10% → 40% → 100%
    ├─ Group 3: (Moonlight) → 2% → 10% → 50%
    ├─ Group 4: (Moonlight) → 50% → 100% → Strobe → SOS  

    Mode 2 - Toggle Memory Mode ON/OF
    Mode 3 - Toggle Moonlight Mode ON/OFF
    Mode 4 - Reverse Group Order
    Mode 5 - Factory Reset
    Restarts from Mode 1; this sequence repeats twice if no option is selected.

    Programming Guide:

    Turn the flashlight ON (full click). From there, half-click/tap the tail-switch 8+ times until it starts to blink (configuration mode).

    If your product has a forward-click switch (only Pineapple mini MK II), start the 8+ half-clicks/taps from ON in half-click position. 

    Hold ON in half-click position once configuration mode is entered and continue with half-clicks/taps and hold to choose modes and groups.  

    Once Configuration Mode is entered, the light will indicate the available configuration options by blinking:

    1 blink → quick flash → 2 blinks → quick flash → 3 blinks → quick flash → 4 blinks → quick flash → 5 blinks → quick flash

    The sequence repeats twice if no option is selected.

    The number of blinks indicates the configuration option to be changed.

    Half-click/tap the tail-switch during the quick flash following the number of blinks to enter the respective configuration mode.


    Configuration Modes:

    Mode 1 - Group Selection(After entering this menu, the light starts a “blink cycle”, which runs twice. The number of blinks indicates the selected group)

    1st blink Group 1 (Moonlight) →   2% →   20% → 100%
    2nd blink Group 2   (Moonlight) → 10% →   40% → 100%
    3rd blink Group 3   (Moonlight) →   2% →   10% →   50%
    4th blink Group 4   (Moonlight) → 50% → 100% → Strobe → SOS

    Half-click/tap the tail-switch after any of the blinks to select the desired group.After the group has been selected, half-click/tap the tail switch to cycle through the brightness steps.

    Mode 2 - Toggle Memory Mode (Default OFF)
    To switch the memory mode ON, half-click/tap the tail-switch during the quick flash after the second blink.
    To switch memory mode OFF, re-enter the configuration mode and repeat the instruction above.

    Mode 3 - Toggle Moonlight Mode (Default ON)
    To switch the moonlight mode OFF, half-click/tap the tail-switch during the quick flash after the third blink.
    To switch the moonlight mode ON again, re-enter the configuration mode and repeat the instruction above.

    Mode 4 - Reverse Group Order (default Low-Medium-High)
    To reverse the order of the selected group from Low-Medium-High to High-Medium-Low, half-click/tap the tail-switch during the quick flash after the fourth blink.
    Repeat to switch back to the original order. 

    Example: By default, the order of Group 1 is: (Moonlight) → 2% → 20% → 100%
    If the order is reversed, Group 1 will be: (Moonlight) → 100% → 20% → 2%

    Mode 5 - Factory Reset
    Half-click/tap the tail-switch during the quick flash after the fifth blink to reset all options to their original settings.

    For a demonstration of the programming procedure, please see demo.